odm s shape carbon fiber ir for pet bottle blowing

Fri, 15 May 2026 18:01:58 +0800

The Heaters We Built for PET Blowing

We designed this ODM heater from the ground up for one job: heating PET preforms. The whole setup is focused on hitting that high thermal demand without messing around. The S-shape isn’t just for looks. It gives you a lot of radiant surface in a tight space, so you get even heat across the preform walls. And it slips straight into your existing blow molding machine. No major overhauls. No headaches.

quartze heating tube a carbon fibre heating lamp

Sat, 09 May 2026 10:01:48 +0800

Introduction

We built this quartz heating tube around a carbon fiber halogen element because we wanted serious heat in a small package. It’s for industrial work where you need heat that shows up fast and stays steady—think heating molds, drying coatings, or keeping process ovens right where you want them.

Technical Deep-Dive

Here’s the practical part: it runs at 400V, so you can drop it straight into higher-voltage plant lines without fussing over step-down gear. At 2500W, it throws off a lot of heat, and at 300mm long, it focuses that power into a tight spot. That means two things. You get rapid warm-up and tight control. But it also means you need to plan cooling and clearance ahead of time. No surprises later if you plan up front.

Pet Blowing Machine Heating 1500w Ir Heater Clear Tube Infrared Halogen Heat Lamp on Heating Lamp Online

odm s shape carbon fiber ir for pet bottle blowing

The Heaters We Built for PET Blowing

quartze heating tube a carbon fibre heating lamp

Introduction

Technical Deep-Dive